Figure 65. Display assembly (for computers shipped with an aluminum chassis)
Steps
1. Open the latch and disconnect the display cable from the connector (LCD) on the system board.
2. Remove the two screws (M2.5x4) that secure the right display hinge to the I/O daughter-board and palm-rest and keyboard
assembly.
3. Using a plastic scribe, lift the right hinge to an angle of 90 degrees from the palm-rest and keyboard assembly.
4. Remove the two screws (M2.5x4) that secure the left display hinge to the system board and palm-rest and keyboard
assembly.
5. Using a plastic scribe, lift the left hinge to an angle of 90 degrees from the palm-rest and keyboard assembly.
6. Peel back the tape that secures the wireless-antenna cables to the system board.
NOTE: This step applies only to computers shipped with a plastic chassis.
7. Remove the wireless-antenna cables from the routing guides on palm-rest and keyboard assembly.
NOTE: This step applies only to computers shipped with a plastic chassis.
8. Gently lift the palm-rest and keyboard assembly at an angle and remove the palm-rest and keyboard assembly from the
display assembly.
CAUTION:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
NOTE: For computers shipped with an aluminum chassis, the display assembly is a Hinge-Up Design (HUD) and cannot
be further disassembled once it has been removed from the computer. If any of the components within the display
assembly is faulty, replace the entire display assembly.
88 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
