Figure 67. Installing the display assembly
Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Hold the palm-rest and keyboard assembly at an angle and slide the palm-rest and keyboard assembly under the display
hinges.
CAUTION:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
3. Route the wireless-antenna cables through the routing guides on the palm-rest and keyboard assembly.
NOTE: This step applies only to computers shipped with a plastic chassis.
4. Adhere the tape to secure the wireless-antenna cables to the system board.
NOTE: This step applies only to computers shipped with a plastic chassis.
5. Gently close the left display hinge and align the screw holes on the left display hinge with the screw holes on the I/O
daughter-board and the palm-rest and keyboard assembly.
6. Replace the two screws (M2.5x4) to secure the left display hinge to the I/O daughter-board and the palm-rest and keyboard
assembly.
7. Gently close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system
board and the palm-rest and keyboard assembly.
8. Replace the two screws (M2.5x4) to secure the right display hinge to the system board and the palm-rest and keyboard
assembly.
9. Connect the display cable to the connector (LCD) on the system board and close the latch.
Next steps
1. Install the wireless card.
NOTE: This step applies only to computers shipped with a plastic chassis.
2. Install the solid-state drive.
3. Install the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
4. Follow the procedure in After working inside your computer.
90
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
