Dell Inspiron 15 AMD - Camera Module (Optional); Removing the Camera Module; Replacing the Camera Module

Back to Contents Page
 Camera Module (Optional)
Dell™Inspiron™1546ServiceManual
Removing the Camera Module
Replacing the Camera Module




Removing the Camera Module

1. Follow the procedures in Before You Begin.

2. Remove the display assembly (see Removing the Display Assembly).

3. Remove the display bezel (see Removing the Display Bezel).

4. Remove the display panel (see Removing the Display Panel).

5. Disconnect the camera cable from the connector on the camera module.

6. Remove the two screws that secure the camera module to the display cover.

7. Remove the camera module.
Replacing the Camera Module

1. Follow the procedures in Before You Begin.

2. Replace the two screws that secure the camera module to the display cover.

3. Connect the camera cable to the connector on the camera module.

4. Replace the display panel (see Replacing the Display Panel).

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
screws (2)
2
camera module
3
camera cable connector

