Removing the Display Panel Cable
1. Follow the procedures in Before You Begin.
2. Remove the display assembly (see Removing the Display Assembly).
3. Remove the display bezel (see Removing the Display Bezel).
4. Remove the display panel (see Removing the Display Panel).
5. Turn the display panel over and place it on a clean surface.
6. Disconnect the display panel cable from the display board connector.
Replacing the Display Panel Cable
1. Follow the procedures in Before You Begin.
2. Connect the display panel cable to the display board connector.
3. Replace the display panel (see Replacing the Display Panel).
4. Replace the display bezel (see Replacing the Display Bezel).
5. Replace the display assembly (see Replacing the Display Assembly).
Display Hinges
Removing the Display Hinges
1. Follow the procedures in Before You Begin.
2. Remove the display assembly (see Removing the Display Assembly).
3. Remove the display bezel (see Removing the Display Bezel).
4. Remove the display panel (see Removing the Display Panel).
5. Remove the two screws (one on each hinge) that secure the display hinges to the display cover.
6. Remove the two hinges.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.