Dell Inspiron 15 AMD - Display Assembly; Removing the Display Assembly; Replacing the Display Assembly

Back to Contents Page
 Display
Dell™Inspiron™1546ServiceManual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
Display Hinges




Display Assembly

Removing the Display Assembly

1. Follow the procedures in Before You Begin.

2. Remove the battery (see Removing the Battery).

3. Remove the module cover (see Removing the Module Cover).

4. Remove the memory module(s) (see Removing the Memory Module(s)).

5. Remove the hard drive (see Removing the Hard Drive).

6. Remove the Mini-Card (see Removing the Mini-Card).

7. Make note of the Mini-Card antenna cables routing and remove the cables from the routing guides.

8. Remove the two screws from the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
Mini-Card cable routing