Replacing the Speakers
1. Follow the procedures in Before You Begin.
2. Place the speakers on the computer base.
3. Replace the four screws (two on each speaker) that secure the speakers to the computer base.
4. Route the speaker cable through the routing guide.
5. Connect the speaker cable to the system board connector.
6. Replace the palm rest (see Replacing the Palm Rest).
7. Connect the Bluetooth board cable to the system board connector (see Replacing the Bluetooth Board).
8. Replace the Bluetooth card (see Replacing the Bluetooth Card).
9. Replace the keyboard (see Replacing the Keyboard).
10. Replace the center control cover (see Replacing the Center Control Cover).
11. Replace the Mini-Card (see Replacing the Mini-Card).
12. Replace the memory module(s) (see Replacing the Memory Module(s)).
13. Replace the module cover (see Replacing the Module Cover).
14. Replace the hard drive (see Replacing the Hard Drive).
15. Replace the battery (see Replacing the Battery).
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
