Replacing the Control-Buttons
Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Connect the control-buttons board cable to the control-buttons board.
2 Slide the control-buttons board into the slot on the display bezel and
adhere the Mylar sheet to the display bezel.
Post-requisites
1 Replace the back cover.
2 Follow the procedure from step 3 to step 5 in “Replacing the Stand
Assembly”.
37
To Next Page
Loading...
