Removing the System-Board
Shield
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Follow the procedure from step 1 to step 5 in “Removing the Stand
Assembly”.
2 Remove the back cover.
Procedure
1 Remove the screws that secure the system-board shield to the display-
panel base.
2 Lift the system-board shield at an angle and remove it from the display-
panel base.
1 system-board shield 2 screws (2)
41
To Next Page
Loading...
