Dell Inspiron 23 - Replacing the Power-Supply Diagnostic Board; Procedure; Post-requisites

Replacing the Power-Supply
Diagnostic Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Connect the power-supply diagnostic board cable to the connector on
the power-supply diagnostic board.
2 Align the screw hole on the power-supply diagnostic board with the
screw hole on the I/O bracket.
3 Replace the screw that secures the power-supply diagnostic board to the
I/O bracket.
Post-requisites
1 Replace the VESA-mount bracket.
2 Replace the system-board shield.
3 Replace the back cover.
4 Replace the stand assembly.
51