Dell Inspiron 2350 - Replacing the Base Cover; Procedure

Replacing the Base Cover | 17
Replacing the Base Cover
WARNING: B efore working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 11. For more safety best practices,
see the Regulatory Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the slots on the base cover into the ports on the system board and snap the
base cover into place.
2 Replace the screws that secure the base cover to the computer base.
3 Tighten the captive screw that secures the base cover to the computer base.
book.book Page 17 Thursday, August 1, 2013 1:03 PM