26 | Removing the USB Board
Removing the USB Board
WARNING:
B
efore working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 11. For more safety best practices,
see the Regulatory Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover. See "Removing the Base Cover" on page 15.
2 Remove the computer base. See "Removing the Computer Base" on page 18.
3 Follow step 1 to step 4 in “Removing the Hard Drive” on page 23.
Procedure
1 Using the pull-tab, disconnect the USB-board cable from the USB board.
2 Remove the screw that secures the USB board to the computer base.
3 Lift the USB board off the computer base.
1USB-board cable 2pull-tab
3screw 4USB board
1
2
3
4
book.book Page 26 Thursday, August 1, 2013 1:03 PM
To Next Page
Loading...
