Dell Inspiron 2350 - Replacing the Computer Base; Procedure; Postrequisites

20 | Replacing the Computer Base
Replacing the Computer Base
WARNING: B efore working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 11. For more safety best practices,
see the Regulatory Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the display cables and antenna cables through the slot on the computer base.
2 Place the computer base on the stand assembly and align the screw holes on the
computer base with the screw holes on the stand assembly.
3 Replace the screws that secure the computer base to the stand assembly.
4 Connect the display cables to the system board.
5 Connect the antenna cables to the wireless mini-card.
Postrequisites
Replace the base cover. See "Replacing the Base Cover" on page 17.
book.book Page 20 Thursday, August 1, 2013 1:03 PM