Table 8. System setup options—Connection menu
Connection
Network Controller Configuration
Integrated NIC Enables or disables integrated NIC.
Default: Enabled with PXE
Wireless Device Enable
WLAN Enable or disable internal WLAN devices.
By default, WLAN is selected.
Bluetooth Enable or disable internal Bluetooth devices.
By default, WLAN and Bluetooth are selected.
Enable UEFI Network Stack Enables or disables UEFI networking protocols, if they are installed and
available.
Default: Auto Enabled
HTTP(s) Boot Feature
HTTP(s) Boot Enables or disables HTTP(s) boot.
Default: ON
HTTP(s) Boot Feature Enables or disables HTTP(s) boot modes
Default: Auto mode
Table 9. System setup options—Power menu
Power
USB PowerShare
Enable USB PowerShare Enables or disables USB PowerShare.
Default: OFF
USB Wake Support
Enable USB Wake Support Enables or disables USB Wake Support.
Default: ON
AC Behavior
AC Recovery Enables to recover the last power state.
Default: Power Off
Block Sleep Blocks the computer from entering Sleep (S3) mode in the operating system.
Default: OFF
NOTE: If enabled, the computer will not go to sleep, Intel Rapid Start will
be disabled automatically, and the operating system power option will be
blank if it was set to Sleep.
Deep Sleep Control
Deep Sleep Control Enable or disable the deep sleep control.
Default: Disabled
Intel Speed Shift Technology Enables or disables the Intel Speed Shift Technology support. Setting this
option to enable allows the operating system to select the appropriate
processor performance automatically.
Default: ON
72 System setup
To Next Page
Loading...
