Dell Inspiron 3593 - Optical-Drive Connector Board; ការលោះផ្ ទា ំ ង ឧរករណ៍ ភា ្ជ រ់ ប្ ោ យអុ រ ទិ ក

Post-requisites
1. Replace the base cover.
2. Replace the optical drive (applicable only to computers shipped with optical drive).
Optical-drive connector board
  

       
      www.dell.com/regulatory_compliance 
Prerequisites
1. Remove the optical drive (applicable only to computers shipped with optical drive).
2. Remove the base cover.
Procedure
NOTE:
Applicable only to computers that are shipped with optical drive.
1. Lift the latch and disconnect the optical-drive connector-board cable from the system board.
2. Remove the screw (M2x2 Big Head) that secures the optical-drive connector board to the palm-rest and keyboard assembly.
3. Lift the optical-drive connector board along with the cable off the palm-rest and keyboard assembly.
24
 