NOTE: The following steps are applicable only to computers that are shipped with optical drive.
7. Press down on the latch to connect the optical-drive connector board cable to the optical-drive connector board.
8. Press down on the latch to connect the optical-drive connector board cable to the system board.
Post-requisites
1. Replace the wireless card.
2. Replace the base cover.
3. Replace the optical drive (applicable only to computers shipped with optical drive).
www.dell.com/regulatory_compliance
Prerequisites
1. Remove the optical drive (applicable only to computers shipped with optical drive).
2. Remove the base cover.
3. Remove the wireless card.
Procedure
1. Remove the three screws (M2.5x5) that secure the left hinge to the system board and palm-rest assembly.
2. Lift the left hinge.
3. Disconnect the power-adapter port cable from the system board.
4. Note the power-adapter port cable routing and remove it from the routing guides on the palm-rest and keyboard assembly.
5. Remove the screw (M2x2) that secures the power-adapter port to the palm-rest and keyboard assembly.
6. Lift the power-adapter port, along with its cable, off the palm-rest and keyboard assembly.
46
To Next Page
Loading...
