www.dell.com/regulatory_compliance
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
1. Route the display cable along the routing guides, starting from the bottom of the display (near the hinges).
2. Route the rest of the display cable along the routing guides on the left side of the display back-cover and antenna assembly.
3. Slide the camera cable into the connector on the camera module to secure the cable.
Post-requisites
1. Replace the display hinges.
2. Replace the display panel.
3. Replace the display bezel.
4. Replace the display assembly.
5. Replace the wireless card.
68
To Next Page
Loading...
