www.dell.com/regulatory_compliance
Procedure
1. Align the screw hole on the optical-drive connector board with the screw hole on the palm-rest and keyboard assembly.
2. Replace the screw (M2x2 Big Head) that secures the optical-drive connector board to the palm-rest and keyboard assembly.
3. Connect the optical-drive connector-board cable to the system board and close the latch that secures the optical-drive connector-
board cable to the system board.
Post-requisites
1. Replace the base cover.
2. Replace the optical drive (applicable only to computers shipped with optical drive).
25
To Next Page
Loading...
