www.dell.com/regulatory_compliance
Procedure
NOTE:
If the rubber grommets are pushed out when removing the speakers, push them back in before replacing the
speakers.
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the system board.
Post-requisites
1. Replace the solid-state drive/Intel Optane.
2. Replace the base cover.
3. Replace the optical drive (applicable only to computers shipped with optical drive).
40
To Next Page
Loading...
