www.dell.com/regulatory_compliance
BIOS
BIOS
Prerequisites
1. Remove the optical drive (applicable only to computers shipped with optical drive).
2. Remove the base cover.
Procedure
CAUTION: Removing the coin-cell battery resets the BIOS setup program’s settings to default. Before removing the
coin-cell battery, it is recommended to note the BIOS setup program’s settings.
Using a plastic scribe, gently pry the coin-cell battery out of the battery socket on the I/O board.
www.dell.com/regulatory_compliance
Procedure
With the positive-side facing up, snap the coin-cell battery into the battery socket on the I/O board.
26
To Next Page
Loading...
