www.dell.com/regulatory_compliance
Prerequisites
1. Remove the optical drive (applicable only to computers shipped with optical drive).
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
5. Remove the display bezel.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
1. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
2. Disconnect the camera cable from the camera module.
3. Lift the camera module from the display back-cover and antenna assembly.
www.dell.com/regulatory_compliance
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
1. Align the camera module with the camera cable.
2. Connect the camera cable to the camera module.
3. Using the alignment post adhere the camera module to the display back-cover and antenna assembly.
62
To Next Page
Loading...
