106 Removing and Installing Parts
4
Release the computer cover by pulling it away from the front of the
computer and lifting it up.
5
Set the cover aside in a secure location.
Removing the Support Bracket
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 103.
2
Remove the computer cover. See "Removing the Computer Cover" on
page 105.
3
Release the card retention bracket by lifting the card retention release lever up.
4
Remove any cable(s) attached to the support bracket cable clamp.
5
Pivot the support bracket and lift it off the hinge tabs.
6
Set it aside in a secure location.
1 computer cover
1
book.book Page 106 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
