Removing and Installing Parts 173
8
Connect your computer and devices to an electrical outlet, and turn them on.
9
Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 88).
Replacing the Support Bracket
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
To replace the support bracket:
1
Align and insert the hinges at the bottom of the support bracket into the
hinge tabs located along the edge of the computer.
2
Pivot the support bracket downward.
3
Align the notch in the support bracket with the slot in the hard drive bay
and press it down.
4
Ensure that the support bracket is seated correctly and replace the card
retention bracket.
book.book Page 173 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
