138 Removing and Installing Parts
Connecting Drive Cables
When you install a drive, you connect two cables—a DC power cable and
a data cable—to the back of the drive.
Drive Interface Connectors
The drive cable connectors are keyed for correct insertion. Properly align the
cable connector key on the cable and the drive before connecting.
1 power cable 2 power input connector 3 data cable
1 interface cable 2 interface connector
1
2
Power Connector
3
Serial ATA Connector
1
2
book.book Page 138 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
