194 Appendix
Clearing CMOS Settings
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 103.
NOTE: The computer must be disconnected from the electrical outlet to clear
the CMOS setting.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 105).
3
Reset the current CMOS settings:
a
Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system
board based on your computer model:
• "Inspiron 530s" on page 191
• "Inspiron 530sa" on page 191
• "Inspiron 530sb" on page 192
• "Inspiron 530sc" on page 192
• "Inspiron 530sd" on page 193
b
Remove the jumper plug from the CMOS jumper (CLEAR CMOS)
pins 2 and 3.
c
Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1
and 2 and wait approximately five seconds.
d
Remove the jumper plug and replace it on the CMOS jumper
(CLEAR CMOS) pins 2 and 3.
4
Replace the computer cover (see "Replacing the Computer Cover" on page 174).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
5
Connect your computer and devices to electrical outlets, and turn them on.
book.book Page 194 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
