132 Removing and Installing Parts
10
Connect any cables that should be attached to the card.
See the documentation for the card for information about the card’s cable
connections.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the
cards can prevent the computer cover from closing properly or cause damage to
the equipment.
NOTICE: To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
11
Replace the computer cover, reconnect the computer and devices to
electrical outlets, and then turn them on.
1 card retention release lever 2 card retention bracket
3 PCI card slot 4 PCI card
2
1
4
3
book.book Page 132 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
