Removing and Installing Parts 141
Installing a Hard Drive
1
Follow the procedures in "Before You Begin" on page 103.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 105).
3
Remove the support bracket (see "Removing the Support Bracket" on
page 106).
4
Check the documentation for the drive to verify that it is configured for
your computer.
5
Attach the shoulder screws to the hard drive.
6
Connect the power and data cables to the drive.
7
Connect the data cable to the system board.
8
Slide the hard drive into the hard drive bay until it snaps in place.
9
Check all cables to be certain that they are properly connected and firmly
seated.
1 hard drive 2 screws(4)
2
1
book.book Page 141 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
