148 Removing and Installing Parts
8
Tighten the two screws on the other side to secure the floppy drive in the
FlexBay drive cage.
9
Slide the FlexBay drive cage along with the floppy drive in the FlexBay slot
till it snaps in place.
10
Attach the power and data cables to the floppy drive.
11
Connect the other end of the data cable to the connector labeled
"FLOPPY" on the system board (see "System Board Components" on
page 109).
12
Check all cable connections, and fold cables out of the way to avoid
blocking airflow between the fan and cooling vents.
13
Replace the CD or DVD drive (see "Installing a CD/DVD Drive" on
page 155).
14
Replace the bezel (see "Replacing the Bezel" on page 136).
1 floppy drive
1
book.book Page 148 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
