About this task
NOTE: The 6-cell battery can be identified by the 78 Wh printout on the left side of the battery.
The following images indicate the location of the 6-cell battery and provides a visual representation of the removal procedure.
Steps
1. Remove the four screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
2. Remove the screw (M1.6x4.5) that secures the battery to the palm-rest and keyboard assembly.
3. Lift the battery off the palm-rest and keyboard assembly.
4. Lift the thermal tape that covers the battery-cable connector on the system board.
5. Disconnect the battery cable from the system board.
6. Remove the battery from the palm-rest and keyboard assembly.
Removing and installing components
19
To Next Page
Loading...
