Steps
1. Lift the Mylar that covers the system board.
2. Peel the thermal tape that covers the M.2 2280 solid-state drive.
3. Remove the screw (M2x2.5) that secures the M.2 2280 solid-state drive/Intel Optane H10 to the palm-rest and keyboard
assembly.
4. Slide and remove the M.2 2280 solid-state drive/Intel Optane H10 from the M.2 card slot on the system board.
Installing the M.2 2280 solid-state drive/Intel Optane H10
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2280 solid-state drive/Intel Optane H10.
NOTE: Depending on the configuration ordered your computer may support the following M.2 cards in the M.2 card slot:
● M.2 2230 solid-state drive + 2230 mounting bracket
● M.2 2280 solid-state drive
● M.2 2280 Intel Optane H10
The following images indicate the location of the M.2 2280 solid-state drive/Intel Optane H10 and provides a visual
representation of the installation procedure.
Removing and installing components
25
To Next Page
Loading...
