5. Remove the screw (M2x3) that secures the power-adapter to the palm-rest and keyboard assembly.
6. Lift the power-adapter port from its slot on the palm-rest and keyboard assembly.
Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the power-adapter port and provides a visual representation of the installation
procedure.
Steps
1. Lift the Mylar that covers the system board.
2. Place the power-adapter port into its slot on the palm-rest and keyboard assembly.
3. Align the screw hole on the power-adapter port to the screw hole on the palm-rest and keyboard assembly.
4. Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
5. Connect the power-adapter port to the connector on the system board.
Removing and installing components
41
To Next Page
Loading...
