About this task
The following images indicate the location of the power-button with optional fingerprint reader and provides a visual
representation of the installation procedure.
Steps
1. Using the alignment posts, place the power-button with optional fingerprint reader into its slot on the palm-rest and
keyboard assembly.
2. Replace the two screws (M2x3) that secure the power-button with optional fingerprint reader to the palm-rest and
keyboard assembly.
3. Connect the power-button cable to the fingerprint-reader board and close the latch.
4. Place the power-button bracket on the power-button with optional fingerprint reader.
5. Align the screw holes on the power-button bracket to the screw holes on the palm-rest and keyboard assembly.
6. Replace the three screws (M2x3) that secure the power-button bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the IO board.
2. Install the fan (4-cell battery) or the fan (6-cell battery), whichever applicable.
3. Install the 4-cell battery or the 6-cell battery, whichever applicable.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Fingerprint-reader board
Removing the fingerprint-reader board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
52
Removing and installing components
To Next Page
Loading...
