8. Peel the tape that secures the antenna cables to the palm-rest and keyboard assembly.
9. Remove the antenna cables from the routing guides on the palm-rest and keyboard assembly.
10. Remove the screw (M2x2.5) that secures the antenna module to the palm-rest and keyboard assembly.
11. Lift the antenna module and its cables off the palm-rest and keyboard assembly.
Installing the antenna module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: The antenna module can only be installed at the location shown on computers shipped with 6-cell battery
configurations.
The following images indicate the location of the antenna module and provides a visual representation of the installation
procedure.
Removing and installing components 45
To Next Page
Loading...
