About this task
NOTE: The antenna module can only be removed from the location shown on computers shipped with 6-cell battery
configurations.
The following images indicate the location of the antenna module and provides a visual representation of the removal procedure.
Steps
1. Lift the Mylar that covers the system board.
2. Peel the tape that secures the antenna cables to the palm-rest and keyboard assembly.
3. Remove the antenna cables from the routing guides on the palm-rest and keyboard assembly.
4. Remove the screw (M2x2.5) that secures the antenna module to the palm-rest and keyboard assembly.
5. Lift the antenna module and its cables off the palm-rest and keyboard assembly.
6. Lift the wireless-card bracket off the system board.
7. Disconnect the antenna cables from the system board.
44
Removing and installing components
To Next Page
Loading...
