Steps
1. Remove the two screws (M2x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
2. Pry open the left-display hinge.
3. Lift the Mylar off the system board.
4. Peel the tape that secures the display-cable latch to the system board.
5. Lift the latch and disconnect the display cable from the system board.
6. Remove the two screws (M2x4) that secure the right-display hinge to the palm-rest and keyboard assembly.
7. Pry open the right-display hinge.
8. Lift the display assembly from the palm-rest and keyboard assembly.
CAUTION:
To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
9. After performing the above steps, you are left with the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components
37
To Next Page
Loading...
