Steps
1. Lift the Mylar that covers the system board.
2. Align the notch on the M.2 2280 solid-state drive/Intel Optane H10 with the tab on the M.2 card slot on the system board.
3. Slide the M.2 2280 solid-state drive/Intel Optane H10 into the M.2 card slot on the system board.
4. Replace the screw (M2x2.5) that secures the M.2 2280 solid-state drive/Intel Optane H10 to the palm-rest and keyboard
assembly.
5. Adhere the thermal tape that covers the M.2 2280 solid-state drive/Intel Optane H10.
6. Place the Mylar over the M.2 2280 solid-state drive/Intel Optane H10.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
26
Removing and installing components
To Next Page
Loading...
