50 Hard Drive
5
Remove the palm-rest assembly (see "Removing the Palm-Rest Assembly"
on page 31).
6
Remove the three screws that secure the hard-drive assembly to the
computer base.
7
Slide the hard-drive assembly to disconnect it from the connector on the
system board.
8
Lift the hard-drive assembly out of the computer base.
CAUTION: When the hard drive is not in the computer, store it in protective
antistatic packaging (see "Protecting Against Electrostatic Discharge" in the
safety instructions that shipped with your computer).
book.book Page 50 Friday, April 13, 2012 2:02 PM
To Next Page
Loading...
