96 Display
Replacing the Display Cable
1
Follow the instructions in "Before You Begin" on page 9.
2
Connect the display cable to the display-board connector and secure it
with the tape.
3
Turn the display panel over and place it on the display back cover.
4
Replace the display panel (see "Replacing the Display Panel" on page 94).
5
Replace the display bezel (see "Replacing the Display Bezel" on page 93).
6
Replace the display assembly (see "Replacing the Display Assembly" on
page 91).
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1 display-cable connector 2 tape
book.book Page 96 Friday, April 13, 2012 2:02 PM
To Next Page
Loading...
