Installing the Bottom Cover
1. Tighten the screws that secure I/O, back door, and HDMI to the computer chassis.
2. Press firmly on the door until a click is heard and latch is engaged.
3. Place the bottom cover on the base of the computer.
4. Tighten the screws that secure the bottom cover to the computer chassis.
5. Install:
a. Optical Drive
b. Hard Drive
c. Battery
6. Follow the procedures in After Working Inside Your computer
Removing the Keyboard
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
3. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the keyboard to the computer chassis [1].
b. Pry along the edges and flip the keyboard over [2].
12
To Next Page
Loading...
