e. Optical Drive
f. Hard Drive
g. Battery
6. Follow the procedures in After Working Inside Your computer
Removing the Display Assembly
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
3. Perform the following steps as shown in the illustration:
a. Lift the locking tab [1].
b. Disconnect the I/O cable [2].
c. Peel the adhesive tape [3].
d. Disconnect the eDP cable on the system board [4].
e. Peel the adhesive tape [5]
f. Disconnect the display assembly cable on the system board [6]
4. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the display assembly connector [1].
b. Lift the tab [2].
c. Disconnect the display assembly connector [3].
24
To Next Page
Loading...
