Dell Latitude 14 Rugged - Installing the Driving Board; Removing the Battery Connector

e. Remove the screws that secure the driving board to the computer [5]
f. Lift the driving board from the computer [6].
Installing the Driving Board
1. Place the driving board on the computer.
2. Tighten the screws that secure the driving board on the computer.
3. Connect the I/O board cable.
4. Affix the adhesive tape.
5. Connect the display assembly cable
6. Affix the tape.
7. Install:
a. Bottom Cover
b. Hard Drive
c. Optical Drive
d. Battery
8. Follow the procedures in After Working Inside Your computer
Removing the Battery Connector
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
e. I/O Board
f.
g.
3. Perform the following steps as shown in the illustration:
a. Disconnect the battery connector cable [1].
b. Remove the screws that secure that battery connector [2].
c. Lift the battery connector [3].
32