Installing the SSD in carrier
1. Connect the SSD to the interposer [1], flip over [2].
2. Install the SSD with interposer on the SSD carrier tray preassembled with new thermal pad [3].
3. Install the cover [1] on the SSD carrier and install the single 'M2*5' screw [2].
4. Flip over the SSD carrier [3] and tighten the two 'M2*5' screws [4] securing the cover to the SSD carrier.
5. Install the:
a) SSD(Primary ).
b) Batteries
6. Follow the procedure in After working inside your computer.
Bottom Chassis Cover
Removing the Bottom Chassis Cover
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) Batteries.
3. Open the left and rear I/O door[1] and loosen the two 'M2.5*6' screws [2] in the rear I/O space.
Removing and installing components
81
To Next Page
Loading...
