Installing the battery
1 Insert the battery into the slot on the system.
2 Route the battery cable through the routing channel.
3 Tighten the M2x6 captive screw to secure the battery to the system.
4 Connect the battery cable to the connector on the system board.
5 Install the base cover.
6 Follow the procedure in After working inside your computer.
SSD card–optional
Removing the SSD card
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the Solid State Drive (SSD) card:
a Peel the adhesive mylar shield that secures the SSD card [1].
NOTE
: Remove the adhesive mylar carefully so that it can be reused on the replacement SSD.
b Remove the M2x3 screw that secures the SSD to the system [2].
c Slide and lift the SSD from the system [3].
18
Disassembly and reassembly
To Next Page
Loading...
