NOTE: This applies only to the SATA M.2 2280 version of the SSD
Installing the SSD card
1 Insert the SSD card into the connector on the system.
2 Replace the M2x3 screw that secures the SSD card to the system.
3 Place the Mylar shield over the SSD.
4 Install the :
a battery
b base cover
5 Follow the procedure in After working inside your computer.
SSD frame
Removing the SSD frame
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
c SSD card
Disassembly and reassembly
19
To Next Page
Loading...
