5. Connect the power-button board FPC to the connector on the system board [1].
6. Route the WLAN antenna cables through the routing guides on the computer [2].
7. Replace the:
a. heat-sink assembly
b. display panel assembly
c. SIM card tray
d. microSD card
8. Follow the procedure in After working inside your tablet.
System Board
Removing system board
Steps
1. Follow the procedure in Before working inside your tablet.
2. Remove the:
a. microSD card
b. SIM card tray
c. battery
d. display panel assembly
e. M.2 2230 SSD
f. WWAN card
g. Rear-facing Camera
h. Heat-sink assembly
i. WWAN main antenna module
3. Disconnect the following cables from the system board .
Disassembly and reassembly
67
To Next Page
Loading...
