5. Peel off the tape on the LCD connections [1] and open the connector [2] to disconnect the EDP cable [3] from the LCD.
6. Peel off the tape on touch connector [4] and disconnect the EDP cable from the connector [5].
Installing the LCD with bezel and the display back cover assembly
1. Replace the EDP cable [1] on the LCD connector and close the actuator [2].
2. Secure the connector using a piece of tape [3] .
3. Connect the touch controller cable [4] and use insulation tape on the connector [5].
104
Removing and installing components
To Next Page
Loading...
