b. Batteries
6. Follow the procedure in After working inside your computer.
Primary SSD Rail
Removing the Primary SSD rail
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. Batteries
b. Primary SSD
c. Bottom chassis cover
d. PCIe heatsink assembly
3. Peel off the inductive tape on the SSD FPC connector [1] on system board and disconnect it [2].
4. Remove the 6 'M2*3' screws [3] and remove it from the computer [4].
Installing the Primary SSD rail
1. Connect the SSD cable [1] to the system board, secure it using a piece of tape [2].
2. Install the primary SSD rail [3] on the system board and tighten the six 'M2*3' screws [4] securing it to the system board.
86
Removing and installing components
To Next Page
Loading...
