Installing the System board
1. Install the system board inserting the serial port on the system board through chassis [1] and install the nine 'M2.5*5' screws
[2] and three 'M2*3' screws [3] on the system board.
2.
NOTE:
When installing the System Board, technicians must ensure that both the battery cables (1st & 2nd Battery) and
FPC cables (Left I/O FPC and Express Card reader FPC) are not pinched under the System Board.
Install the USB Type-C bracket [1] and secure it with two 'M2.5*5' screws and two 'M1.6*3.0' screws on the system board
[2].
Removing and installing components
129
To Next Page
Loading...
