3. Connect the power button cable [1] to the system board and secure it using a piece of tape [2].
4. Connect the USH board and touch pad cable [3] to the system board and secure it using a piece of tape [4].
5. Insert the left I/O FPC cable through the wall bridge[1] and connect it to the motherboard [2] securing it using a piece of
tape [3].
6. Peel off the tape [4] on the express card FPC and connect it to the system board [5].
7. Stick the tape back on the connector on the system board [6] and secure it with some extra tape [7].
130
Removing and installing components
To Next Page
Loading...
