13. Peel off the tape [1] to disconnect the left I/O board FPC connector [2] and pass it through the wall bridge [3].
14. Peel off the tape on the express card FPC connectors [4] and an extra tape on the connector [5] on the system board.
15. Disconnect the express card FPC connector [6] and pass it through the wall bridge [7].
16. Peel off the tape [1] and disconnect the power button FPC connector [2] from the system board.
17. Peel off the tape [3] and disconnect the USH board FPC and touch pad connectors [4] from the system board.
Removing and installing components
127
To Next Page
Loading...
