About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
Steps
1. Using a plastic scribe pry open the solid-state drive shielding cover from the recess at the bottom edge of the solid-state
drive shielding cover.
2. Remove the solid-state drive shielding cover from the system.
3. Remove the single (M1.6x2.5) screw securing the solid-state drive to the system board.
4. Slide and remove the solid-state drive from the solid-state drive slot on the system board.
NOTE: If the thermal pad located underneath the M.2 2230 SSD gets detached, adhere it back to the system board.
Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Removing and installing components
21
To Next Page
Loading...
